INSTALLATION INSTRUCTIONS IHS RPMS CHR REPORTING SYSTEM VERSION 1.0 PATCH 3 ======================================================================= **** NOTE***** NOTE **** NOTE **** NOTE **** NOTE **** NOTE **** NOTE * ************************************************************************ ************************************************************************ * READ THE ENTIRE NOTES FILE PRIOR TO ATTEMPTING ANY INSTALLATION !!!* ************************************************************************ **** NOTE ***** NOTE **** NOTE **** NOTE **** NOTE **** NOTE **** NOTE * 1. GENERAL INFORMATION a) Print all notes/readme files. b) It is recommended that the terminal output during the installation be captured using an auxport printer attached to the terminal at which you are performing the software installation. This will insure a printed audit trail if any problems should arise. c) This patch corrects the following problems: 1. The system does not currently allow a service time of 0. This patch corrects that problem. The data dictionary field and chr-pcc link routine have been modified. 2. Fixes the pre-export check routine to properly print the CHR. 2. CONTENTS OF DISTRIBUTION a) bch_0100.03p - patch 3 routine b) bch_0100.03n - notes file for patch 3 3. REQUIREMENTS ****This patch should only be installed AFTER you have installed the 1997 ICD Update******** 4. INSTALLATION INSTRUCTIONS a. Do a routine restore (^%RR) from file bch_0100.03p b. D ^BCH2INIT answer yes to all questions, after this is done you may delete routines BCH2I* IF YOU HAVE NOT ALREADY INSTALLED PATCHES 1-2, DO THE FOLLOWING: c. Run routine BCH10P1 (D ^BCH10P1) d. You may now delete routine BCH10P1 e. Run routine ^BCH1INIT f. You may now delete routines BCH1I* 5. POINT OF CONTACT DAVE RIVARD INFORMATION SYSTEMS DIVISION, TUCSON 520-295-2533 Patch 3 contains the following routines: BCH10P1 BCH1* BCH2* BCHABCH BCHDHS BCHEXDI2 BCHHS BCHUFP BCHUFPP BCHEXCP